- Messages
- 146
When I had my Tiger painted the shop that did it pulled the doors, trim etc. Unfortunately, when they reassembled the car I think they did a poor job on my door alignment.
The problem I have is the rear edge of the door does not sit flush with the rest of the rear quarter panel. I would guess approx. 1/8 to 3/16 inches stick out. Makes the door look like its not shut in my opinion. My question is what part of the door would I have to adjust to remedy this issue. What would I need to do.
The doors definitely fit better before they pulled them. Its not bad but bugs me to no end. Can't go back to the shop because they have moved on.
Any ideas or recommendations greatly appreciated.
thanks
Dave
The problem I have is the rear edge of the door does not sit flush with the rest of the rear quarter panel. I would guess approx. 1/8 to 3/16 inches stick out. Makes the door look like its not shut in my opinion. My question is what part of the door would I have to adjust to remedy this issue. What would I need to do.
The doors definitely fit better before they pulled them. Its not bad but bugs me to no end. Can't go back to the shop because they have moved on.
Any ideas or recommendations greatly appreciated.
thanks
Dave