Apparently there was an article in Tiger Tales by Dan Walters on how to fit Mustang brakes. I am interested in the rears.
I think this must have been around 06-07
Anyone know about this mod?
This article would be great reading; hope that someone can find it.
Cheers, Doug
Apparently there was an article in Tiger Tales by Dan Walters on how to fit Mustang brakes. I am interested in the rears.
I think this must have been around 06-07
Anyone know about this mod?
Did you look through the old Tiger Tales that are posted on the Forum? You must be signed in as a C.A.T. member to access the Tiger Tales section.
Did you look through the old Tiger Tales that are posted on the Forum? You must be signed in as a C.A.T. member to access the Tiger Tales section.
Mustang II discs methinks ??
Did you look through the old Tiger Tales that are posted on the Forum? You must be signed in as a C.A.T. member to access the Tiger Tales section.
Mustang II discs methinks ??
Did the Mustang ll not use a front hub/rotor combo? Or is this an aftermarket rotor
Centric 121.61026
Rotor Style: Plain
Outside Diameter: 277mm (10.91")
Rotor Height: 95.3mm (3.75")
Nominal Thickness: 26.1mm (1.03")
Minimum Thickness: 24.7mm (0.97")
Hub Hole Diameter: 63.7mm (2.51")
Stud Hole Size: 1/2 x 20
Bolt Circle: 108mm (4.25")
Those are Must II stock rears with the E-brake lever/cable, etc.
If Mustang ll part, they might be Grenada front rotors that is the spec I posted. Granada is the 11" upgrade for the hot rod Mustang ll front ends and I have one in my 1960 Stude pickup
Centric 121.61026
Rotor Style: Plain
Outside Diameter: 277mm (10.91")
Rotor Height: 95.3mm (3.75")
Nominal Thickness: 26.1mm (1.03")
Minimum Thickness: 24.7mm (0.97")
Hub Hole Diameter: 63.7mm (2.51")
Stud Hole Size: 1/2 x 20
Bolt Circle: 108mm (4.25")
The units in our photo came from Dale as a kit. It both fit and worked quite well.
If Mustang ll part, they might be Grenada front rotors that is the spec I posted. Granada is the 11" upgrade for the hot rod Mustang ll front ends and I have one in my 1960 Stude pickup
Centric 121.61026
Rotor Style: Plain
Outside Diameter: 277mm (10.91")
Rotor Height: 95.3mm (3.75")
Nominal Thickness: 26.1mm (1.03")
Minimum Thickness: 24.7mm (0.97")
Hub Hole Diameter: 63.7mm (2.51")
Stud Hole Size: 1/2 x 20
Bolt Circle: 108mm (4.25")