Dash wiring v2.00

[sandy]

Making some changes to the wiring. Adding a tap for the driver "panic" box with the master kill switch for tunnel mount control. Adding new connectors for the gauges since I hate the ones supplied and wires supplied which are only rated for 80C or 174F... nope. All other existing wiring is Teflon, just because.

Finally fixing and issue with one relay that was wired not to my liking and swapped out a push button with a 3 way for fan controller. Looks bad but not really. Also updating the Sharpie marked tags with one's that I can actually read.

Once done will fit up to get wire lengths for the bulkhead connector and things like wiper, MSD box, and lastly the wireless horn module.

 

[Warren]

Wow, where's the flux capacitor hook up

 

[theo_s]

Where did you get the Teflon wiring from? You were able to get specific base and stripe colors?

 

[sandy]

Where did you get the Teflon wiring from? You were able to get specific base and stripe colors?

Just had a big stash I had collected over the years. Some from an Aircraft Surplus near me (Apex electronics) rest from EBay. Hard to find and got really expensive. Engine side will be a mix of Teflon and GXL as almost out of Teflon. The GXL is nice as I have many colors and striped. The Teflon I had was limited in colors.