Hi all.
I have a problem that hopefully you can help we with.
I've been reassembling my front suspension and have got to the point where I have to set the end float on the hub bearings.
According to the manual there should be an end float of between 0.002" to 0.007" so I set it in accordance with the worshop manual by torquing up the nut and then releasing it until the required end float was achieved.
I made a little fixture to measure the end float.
I set the bearings at both sides to around 0.003".
Now, with the road wheel reattached, when I put my hands at the top and bottom of the wheel and rock it, there is a bit of play and an audible clunk.
Is this normal?
How do you set your bearings?
Many Thanks.
I have a problem that hopefully you can help we with.
I've been reassembling my front suspension and have got to the point where I have to set the end float on the hub bearings.
According to the manual there should be an end float of between 0.002" to 0.007" so I set it in accordance with the worshop manual by torquing up the nut and then releasing it until the required end float was achieved.
I made a little fixture to measure the end float.
I set the bearings at both sides to around 0.003".
Now, with the road wheel reattached, when I put my hands at the top and bottom of the wheel and rock it, there is a bit of play and an audible clunk.
Is this normal?
How do you set your bearings?
Many Thanks.
Last edited: